The Mathematical Institute at Oxford is advertising three post-doctoral positions within the Oxford Centre for Collaborative Applied Mathematics for(ideally) a 1st April 2011 start. The project titles (with links for more information) are:
1. Brain Mechanics, Cortex Folding, and Pattern Formation in Growing Tissues.
http://www.maths.ox.ac.uk/node/1405
Good morning
I'm working in Abaqus on drying modeling. Regards this i have two questions.
1)Drying modeling is possible in Abaqus
2)I would like to ask if it is possible for Abaqus to model drying how can i create automatic crack propagation in 2D or 3D
P.S. sorry for my english, i hope everything is clear enough to understand this post. i hope someone can help me.
Regards
Mohsen Heydari
Dear Colleagues,
I wish to bring to your attention my recent work with Mrinal Iyer on a field theoretic approach to the quasi-continuum method to appear in Journal of the Mechanics and Physics of Solids. Below is the abstract and attached is the preprint of the article. I will very much appreciate your comments and suggestions.
A Field Theoretic Approach to the Quasi-Continuum Method
In Abaqus .inp or Abaqus/CAE, are there mesh generation commands similar to ANSYS commands FILL, NGEN, and EGEN used to geneate nodes (between keypoints) and elements ?
Brown University established a School of Engineering on July 1, 2010 and is beginning a major hiring initiative to fill multiple openings. As part of this initiative, the School is seeking to fill a position in Solid Mechanics at any academic level to start in July 2011.
For the most up to date corrections to the book, go to http://forum.cadec-online.com/viewtopic.php?f=9&t=34
For the most up to date ERRATA, go to http://www.mae.wvu.edu/barbero/feacm/errata_feacm.htm
i am working on the stability analysis of cantilever shaft disk 9rotor) systems. i am a beginner in this work. can any one please suggest any books or papers which can help me in my work. i will be grateful to you.
Adhesive bonding is contemplated as an alternative method to mechanical fastening for joining composite aerostructures.
Ongoing research in this area is focused on the development of new bonding techniques and joining elements. In this
article, the mechanical performance of the novel noncrimp fabric (NCF) H-shaped adhesively bonded joints subjected to
tension, shear and four-point bending loading conditions was investigated by both experimental tests and numerical
Can anyone guide me how to get crosshead speed range equal to or greater than 1:3000 in a motorized electromechanical material testing machine? The load capacity should remain same even at lowest speed.
